![]() Lock the lever and tighten the lock knob to hold the table and saw head in position. Loosen the miter lock handle and rotate the turntable to the desired angle indicated on the miter gauge. Use a STOP BLOCK when cutting parts of equal length. ![]() Release the power switch raise the saw head and allow blade to fully stop. Push the saw head down until the blade passes through the stock. Secure stock tightly against the table and back fence. The blade must reach full speed before lowering into stock. Secure stock tightly against the table and back fence.Ĥ Specific Safety Con’t Make sure the blade is not in contact with the stock before pressing the power switch. 2 SPECIFIC PURPOSE To cross-cut to finish length and to make miter and bevel cuts.ģ SPECIFIC SAFETY RULES NEVER make rip cuts.Īlways keep one hand on the handle with the power switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |